Electri-Glass Home
Contact Us
Quality fiberglass hill holders are manufactured by ELECTRI-GLASS, Inc.
           Composite - Fiberglass Hill Holders

Single-Phase Transformer Box Pads
Three-Phase Transformer Box Pads
Electrical Handhold Boxes - Hand Hold Box - Handholes Box - Splice Boxes - Pull Box
Switchgear Pads - Vaults. Switchgear Box Pad
Cabinet Bases, Cabinet Foundations for Sectionalizing Cabinets, Fusing Cabinets, etc
Hill Holders
 
Electri-Glass composite - fiberglass hill holders are used on sloping terrain to prevent washout and corrosion of your equipment by blocking dirt and rocks from falling on or against it. Our hill holders are ideally suited for use with pad mounted equipment or telephone or cable equipment that is installed on a hill or sloped surface.


composite - fiberglass hill holder


  • constructed from durable, non-conductive, corrosive resistant fiberglass reinforced polyester resin

  • external ribs on all models

  • gel-coated for maximum UV protection

  • protection from dirt accumulation against side of enclosure

  • reduced installation cost vs concrete poured in place

  • lightweight, easily installed and leveled

  Key dimensions for the hill holders are shown below.
Click on "PDF" next to each item for additional information

 
KEY DIMENSIONS
(inches)
HILL HOLDER
CAT. NO.
A
LENGTH
B
WIDTH
C
HT.
Click below for
PDF File
EGHH-484612
48
46
12
PDF
EGHH-484924
48
49
24
PDF
EGHH-494632
49
46
32
PDF