63 Compass Drive,  Jackson, TN 38301 Email: office@eglasstn.com       Phone: 731-427-0433 Composite - Fiberglass Hill Holders

Electri-Glass composite - fiberglass hill holders are used on sloping terrain to prevent washout and corrosion of your equipment by blocking dirt and rocks from falling on or against it. Our hill holders are ideally suited for use with pad mounted equipment or telephone or cable equipment that is installed on a hill or sloped surface.

constructed from durable, non-conductive, corrosive resistant fiberglass reinforced polyester resin external ribs on all models gel-coated for maximum UV protection protection from dirt accumulation against side of enclosure reduced installation cost vs concrete poured in place lightweight, easily installed and leveled

Key dimensions for the hill holders are shown below. Click on "PDF" next to each item for additional information

KEY DIMENSIONS (inches) HILL HOLDER CAT. NO. A LENGTH B WIDTH C HT. Click below for PDF File EGHH-484612 48 46 12 PDF EGHH-484924 48 49 24 PDF EGHH-494632 49 46 32 PDF